This is smart heating

Our most sought-after products are There Direct and There Waterborne. One of them suits almost all electrically detached, semi-detached, row and summer houses.

For direct electrical heating

There Direct

Product package for you with direct electrical heating (with wall-mounted radiators, non-storing underfloor or ceiling heating) and/or possible heat-storing or partially storing underfloor heating. Also for houses with a combination of these in different parts of the building. System also controls your possible domestic hot water tank. 

System secures desired inside temperatures and minimizes the cost of electricity used for heating. The savings are made by reducing the amount of heating energy by lowering temperatures in various living situations according to your expectations, and shifting heating to less expensive hours. This is done by taking into account building insulation (heat storage capacity), weather forecast, electricity spot price and allowing a temperature variation range defined by you. 

The product consists of three devices: central unit, control relay and one temperature sensor. Your home temperature is controlled based on the temperature measurement.

You can expand the package with needed amount of additional temperature sensors if your home has more than one floor or wing, or different heating methods in different areas. You can also connect possible air-to-air heat pumps to it.

For waterborne underfloor electrical heating

There Waterborne

Product package for you with waterborne underfloor electrical heating, with a water tank of at least 1 500 liters. System also controls your possible separate domestic hot water tank.

System secures desired inside temperature and minimizes the cost of electricity used for heating. The savings are made by shifting heating of the tank to less expensive hours. This is done by taking into account the daily heating energy needed by the building, depending on outside temperature, and selecting the cheapest hours to produce the energy.

The product consists of three devices: central unit, control relay and one temperature sensor. Your home temperature is controlled by room thermostats as before. The measured temperature is indicated to you in user interface.

You can expand the package by connecting possible air-to-air heat pumps to it.

Frequently asked

You can open/close:
1. All questions under one topic (by clicking the topic)
2. Answer to one question (click “+/-“)
3. All questions and answers under all topics (click ”Expand/Collapse all”)

Expansion possibilities

Sure. All you need is a three-phase current meter and a control relay from our online shop. The charging logic is usually configured so that loads e.g. warm water boiler or EV charging are connected when PV production is available. Logic can be configured easily from the installation user interface. It does not require any changes to the system.

Sure. A wireless controller is available in our online shop. It receives automatic control commands from the gateway, and transmits them with infrared to your air-to-air heat pump, just like your present IR remote controller. After you have our controller, you no longer need your old one.
The controller is configured easily to the system, like an additional temperature sensor. No changes are needed.

At the moment we support heat pumps from following manufacturers: Green, Mitsubishi, Panasonic. The list is updated continuously.

Sure. All you need is a wireless control relay you can find in our online shop. The charging logic is usually configured so that you tell how many hours you want to charge your EV and the system selects the cheapest hours for you. Logic can be configured easily from the installation user interface. It does not require any changes to the system.

Yes. We test and add continuously new WiFi/MQTT compatible sensors. Our SW is already set up for that. It has extensive smart home functionality, allowing configuration of sensors and their logics.

System can e.g. be configured to send an SMS alarm when a sensor is activated. Or, equally well, an audible alarm, lights etc. can be turned on. One more sophisticated example could be turning on your yard lights, when a smart phone of one of your family members arrives in your WiFi network. And so on.

Configuring logics is simple from the installation user display and needs no system changes. A skilled user can do it her/himself.

Load More

Cart Item Removed. Undo
  • No products in the cart.
Copy link
Powered by Social Snap